WARRANTY POLICY
AIM Equipment (Pty) Ltd warrants that at date of commissioning all articles supplied will be free of defects in material and workmanship.
AIM Equipment (Pty) Ltd agrees to correct any defective article or part thereof , provided that AIM Equipment (Pty) Ltd was advised in writing of the existence of such defectiveness within the “WARRANTY TIME PERIOD” described herein and provided that such defective article is made available for inspection at the AIM Equipment (Pty) Ltd premises at Delmas.
The warranty does not cover:
1.) Electrical components
2.) Pneumatic components
3.) Hydraulic components (Unless proven to be poor workmanship).
AIM Equipment (Pty) Ltd shall limit its liability to the correction or replacement of defective parts. This shall be the maximum liability and AIM Equipment (Pty) Ltd shall never be liable for consequential damages.
AIM Equipment (Pty) Ltd shall not be liable for any of the following:
> Labor costs in removing or re-installing articles or parts thereof,
> Transportation of articles / products to and from AIM’s premises, Replenishment of fluids such as lubricants,
> Any warranty issued by its own supplier greater than the scope of warranty as set out above,
> Accommodation nor traveling for personnel.
AIM Equipment (Pty) Ltd reserves the right to repair or replace any item under warranty at its own discretion.
All warranty claims will be made good at the AIM Equipment (Pty) Ltd premises at Delmas.
WARRANTY TIME PERIOD
Twelve months for new equipment from date of supply, provided that there is a record of service by AIM Equipment (Pty) Ltd for the period preceding the date of the warranty claim.
Six months for repaired equipment provided there is a record of service by AIM Equipment (Pty) Ltd within this six month period.
Record of such service to be proven and substantiated by Aim Equipment (Pty) Ltd or service agent, provided that such service agents are approved by AIM Equipment (Pty) Ltd.
No warranty on second-hand equipment, components or parts.
Warranty Claim Procedure.
All warranty claims will follow the standard job process of ordering, performing the work or repair/s, invoicing and payment. Suspected components will be sent to their manufacturer where the warranty claim will be subject to said manufacturer’s warranty procedures.
Only after the warranty has been approved will credit be allocated towards the customer. Equipment, components or parts will not be released until the full job process is completed.
STATUS OF UNITS SENT FOR WARRANTY
Should any item under warranty be stripped, opened or worked on by anybody other than AIM Equipment (Pty) Ltd prior to AIM Equipment (Pty) Ltd receiving the item, then AIM Equipment (Pty) Ltd will not be bound to offer any warranty on the item whatsoever.
Web Site Terms and Conditions of Use
1. Terms
By accessing this web site, you are agreeing to be bound by these web site Terms and Conditions of Use, all applicable laws and regulations, and agree that you are responsible for compliance with any applicable local laws. If you do not agree with any of these terms, you are prohibited from using or accessing this site. The materials contained in this web site are protected by applicable copyright and trade mark law.
2. Use License
Permission is granted to temporarily download one copy of the materials (information or software) on AIM Equipment (Pty) Ltd's web site for personal, non-commercial transitory viewing only. This is the grant of a license, not a transfer of title, and under this license you may not:
modify or copy the materials;
use the materials for any commercial purpose, or for any public display (commercial or non-commercial);
attempt to decompile or reverse engineer any software contained on AIM Equipment (Pty) Ltd's web site;
remove any copyright or other proprietary notations from the materials; or
transfer the materials to another person or "mirror" the materials on any other server.
This license shall automatically terminate if you violate any of these restrictions and may be terminated by AIM Equipment (Pty) Ltd at any time. Upon terminating your viewing of these materials or upon the termination of this license, you must destroy any downloaded materials in your possession whether in electronic or printed format.
3. Disclaimer
The materials on AIM Equipment (Pty) Ltd's web site are provided "as is". AIM Equipment (Pty) Ltd makes no warranties, expressed or implied, and hereby disclaims and negates all other warranties, including without limitation, implied warranties or conditions of merchantability, fitness for a particular purpose, or non-infringement of intellectual property or other violation of rights. Further, AIM Equipment (Pty) Ltd does not warrant or make any representations concerning the accuracy, likely results, or reliability of the use of the materials on its Internet web site or otherwise relating to such materials or on any sites linked to this site.
4. Limitations
In no event shall AIM Equipment (Pty) Ltd or its suppliers be liable for any damages (including, without limitation, damages for loss of data or profit, or due to business interruption,) arising out of the use or inability to use the materials on AIM Equipment (Pty) Ltd's Internet site, even if AIM Equipment (Pty) Ltd or a AIM Equipment (Pty) Ltd authorized representative has been notified orally or in writing of the possibility of such damage. Because some jurisdictions do not allow limitations on implied warranties, or limitations of liability for consequential or incidental damages, these limitations may not apply to you.
5. Revisions and Errata
The materials appearing on AIM Equipment (Pty) Ltd's web site could include technical, typographical, or photographic errors. AIM Equipment (Pty) Ltd does not warrant that any of the materials on its web site are accurate, complete, or current. AIM Equipment (Pty) Ltd may make changes to the materials contained on its web site at any time without notice. AIM Equipment (Pty) Ltd does not, however, make any commitment to update the materials.
6. Links
AIM Equipment (Pty) Ltd has not reviewed all of the sites linked to its Internet web site and is not responsible for the contents of any such linked site. The inclusion of any link does not imply endorsement by AIM Equipment (Pty) Ltd of the site. Use of any such linked web site is at the user's own risk.
7. Site Terms of Use Modifications
AIM Equipment (Pty) Ltd may revise these terms of use for its web site at any time without notice. By using this web site you are agreeing to be bound by the then current version of these Terms and Conditions of Use.
8. Governing Law
Any claim relating to AIM Equipment (Pty) Ltd's web site shall be governed by the laws of the State of Gauteng without regard to its conflict of law provisions.
General Terms and Conditions applicable to Use of a Web Site.
Privacy Policy
Your privacy is very important to us. Accordingly, we have developed this Policy in order for you to understand how we collect, use, communicate and disclose and make use of personal information. The following outlines our privacy policy.
Before or at the time of collecting personal information, we will identify the purposes for which information is being collected.
We will collect and use of personal information solely with the objective of fulfilling those purposes specified by us and for other compatible purposes, unless we obtain the consent of the individual concerned or as required by law.
We will only retain personal information as long as necessary for the fulfillment of those purposes.
We will collect personal information by lawful and fair means and, where appropriate, with the knowledge or consent of the individual concerned.
Personal data should be relevant to the purposes for which it is to be used, and, to the extent necessary for those purposes, should be accurate, complete, and up-to-date.
We will protect personal information by reasonable security safeguards against loss or theft, as well as unauthorized access, disclosure, copying, use or modification.
We will make readily available to customers information about our policies and practices relating to the management of personal information.
We are committed to conducting our business in accordance with these principles in order to ensure that the confidentiality of personal information is protected and maintained.
All goods remain the property of Aim Equipment (Pty) ltd until paid in full.
